Agilent Technologies G7077B User Manual

5 Operating in EI Mode
Operating the MSD from the 7890 GC Control Panel
106 5977B Series MSD Operating Manual
To view the firmware version of the MSD from the GC control panel
1 Press MS/Aux Det to bring up the 5977B MSD menu.
2 Press the down arrow to scroll to Firmware.
To view the serial number of the MSD from the GC control panel
1 Press MS/Aux Det to bring up the 5977B MSD menu.
2 Press the down arrow to scroll to Serial#.
To configure the network settings for the MSD from the GC control panel
1 Press Config, and then press MS/Aux Det to bring up the CONFIGURE MS
DETECTOR menu.
2 To configure the IP: parameter, use the GC keypad to enter the new IP
address for the MSD, then press Enter to complete the entry.
3 Wait for the GC to display the new IP address. Reboot the MSD or proceed to
the gateway address with the down arrow.
4 Press the down arrow to scroll to GW: and use the GC keypad to enter the
new gateway address for the LAN and press Enter to complete the entry.
5 Press the down arrow to scroll to SW: and use the GC keypad to enter the
new subnet mask for the LAN and press Enter to complete the entry.
6 Reboot the MSD. (See below.)
To reboot the MSD from the GC control panel
1 Press Config, and then press MS/Aux Det to bring up the CONFIGURE MS
DETECTOR menu.
2 Press the down arrow to scroll to Request MSD Reboot?.
3 Press On/Yes to reboot the MSD and wait for the MSD to complete this cycle
before trying to access it. The LED turns red until the reboot cycle is
completed.

Agilent Technologies G7077B Specifications

General

Brand	Agilent Technologies
Model	G7077B
Category	Water Pump
Language	English