Agilent Technologies G7077B User Manual

5 Operating in EI Mode
Operating the MSD from the 7890 GC Control Panel
5977B Series MSD Operating Manual 107
To enable/disable BOOTP on MSD
By default, the BOOTP is disabled. If your LAN uses a BootP server, Enabling
BOOTP causes the server to automatically assign an IP address to the MSD.
1 Press Config, and then press MS/Aux Det to bring up the CONFIGURE MS
DETECTOR menu.
2 Press the down arrow to scroll to MSD BOOTP.
3 To enable BOOTP, press On/Yes.
To disable BOOTP, press Off/No.
4 Wait for the MSD to confirm the change on the GC control panel.
5 Reboot the MSD. (See “To reboot the MSD from the GC control panel” on
page 106.)

Agilent Technologies G7077B Specifications

General

Brand	Agilent Technologies
Model	G7077B
Category	Water Pump
Language	English