1260 Infinity II Flexible Pump User Manual 71
3Using the Module
Setting up the Pump with the Instrument Control Interface
Setting up the Pump with the Instrument Control
Interface
Overview
Parameters described in following sections are offered by the instrument control
interface and can usually be accessed through Agilent instrument control
software. For details, please refer to manuals and online help of respective user
interfaces.
Instrument Configuration
Use the Instrument Configuration dialog box to examine and, if necessary, modify
your instrument configuration. The Configurable Modules panel contains a list of
all modules available for configuration. The Selected Modules panel contains the
list of configured modules.
Auto Configuration: Under Communication settings, select either the Host Name
option or the IP address option and enter the appropriate value for the host
computer to enable automatic detection of the hardware configuration. The
system configures the instrument automatically with no further manual
configuration necessary.
The Quaternary Pump configuration parameters are in two sections:
• Communication
•Options
Communication: The parameters in this dialog box are detected automatically
during autoconfiguration.
•Device name,
•Type ID,
• Serial number,
•Firmware revision,
• Connection settings
To Next Page
Loading...
Need help?
General
