Agilent InfinityLab LC Series Diode Array Detectors User Manual 170
9 Maintenance
Replace the Module Firmware
Replace the Module Firmware
To upgrade/downgrade the module’s firmware carry out the following steps:
1 Download the required module firmware, the latest FW Update Tool and the
documentation from the Agilent web.
http://www.agilent.com/en-us/firmwareDownload?whid=69761
2 For loading the firmware into the module follow the instructions in the
documentation.
Module Specific Information
When
The installation of newer firmware might be necessary
• if a newer version solves problems of older versions or
• to keep all systems on the same (validated) revision.
The installation of older firmware might be necessary
• to keep all systems on the same (validated) revision or
• if a new module with newer firmware is added to a system or
• if third party control software requires a special version.
Tools required Description
Agilent Lab Advisor software
Parts required # Description
1 Firmware, tools and documentation from Agilent web site
Preparations
Read update documentation provided with the Firmware Update Tool.
Table 25 Module Specific Information (G7117A/G7117B/G7117C)
G7117B 1290 DAD G7117A 1290 DAD FS G7117C 1260 DAD HS
Initial firmware (main
and resident)
D.06.70 D.07.01
Compatibility with
1100/1200/1260/
1290 series modules
When using the detector in a system, all other modules must have firmware from set 6.50 (latest ver-
sion) or later (main and resident). Otherwise the communication will not work.
Conversion to / emula-
tion
G4212A, G4212B, G7117A G4212B -
To Next Page
Loading...
Need help?
General
