15
Order online at www.agilent.com/chem/store
Gas Management
Agilent recommends using copper tubing for most applications, since it is easy to bend
and plumb and is less expensive than stainless steel. Use stainless steel tubing only for
crucial applications that require very high purity, or where building codes mandate its use.
Before any tubing is placed into service,
or if it becomes contaminated with use,
it is essential that it be properly cleaned.
Unclean or improperly cleaned tubing can
lead to contamination of the system with
disastrous results. Never use chlorinated
solvents to clean tubing or fittings.
Agilent provides clean, high quality
GC grade tubing for large systems as
an economical alternative.
Determining Tubing Length
Parameters: 2000 sccm (4.2 scfh); Temperature: 70°F; Pressure 30 psig
Tubing Type Diameter
(inches)
Recommended
Max. Length (feet)
Pressure Drop
(psig)
Copper 1/8 50 2
Copper 1/4* 300 0.5
*Recommended when multiple instruments are connected to the same source
Tubing - Precleaned
Description Part No.
Copper tubing, 1/8 in., 50 ft 5180-4196
Copper tubing, 1/8 in., 12 ft 5021-7107
Fittings
Description Part No.
Fittings Kit
Includes brass nuts, ferrules, caps, plugs, unions and reducers
5180-4161
1/8 in. brass nut and ferrule set 5080-8750
Cylinder wall bracket
Description Part No.
Cylinder wall bracket with strap & chain
(cylinder size up to 14 in., 35 cm)
5183-1941
Cleaning Tubing
Cylinder wall bracket, 5183-1941
Tubing
To Next Page
Loading...
Need help?
General
