Agilent Technologies gc/ms series User Manual

7
Order online at www.agilent.com/chem/store
Gas Management
Indicating moisture traps are available in
plastic and glass bodies. Glass body traps
are used when potential contaminants
from plastic trap bodies are a concern.
Glass traps are normally encased in a
protective, plastic shrink wrap or a high
impact plastic shield (outer trap body).
Glass and plastic bodied traps are usually
pressure tested at 150 psi, thus they are
safe for use at the typical pressures
required by the GC.
Moisture Traps
Description Size
(cc)
Removal
Capacity (g)
Max.
Effluent H
2
O
Concentration
(ppb)
1/8 in.
Part No.
1/4 in.
Part No.
Molecular Sieve 13X and Indicating 4A (MT Series)
Refillable
Moisture Trap
120 21.6 20 MT120-2 MT120-4
Refillable
Moisture Trap
200 36.0 18 MT200-2 MT200-4
Refillable
Moisture Trap
400 72.0 14 MT400-2 MT400-4
Adsorbent refill (1 pint) for MT series MSR-1 MSR-1
Molecular Sieve 5A and Indicating Drierite (MT-D Series)
Refillable
Moisture Trap
120 21.6 22 MT120-2-D MT120-4-D
Refillable
Moisture Trap
200 36.0 20 MT200-2-D MT200-4-D
Refillable
Moisture Trap
400 72.0 16 MT400-2-D MT400-4-D
Adsorbent Refill (1 pint) for MT-D Series MSR-2 MSR-2
Tips & Tools
Moisture traps are highly
recommended for carrier
and ECD gases.
M
oisture trap
Moisture (Water) Traps

Agilent Technologies gc/ms series Specifications

General

Brand	Agilent Technologies
Model	gc/ms series
Category	Laboratory Equipment
Language	English