Agilent Technologies PSA Series Installation Note

10 Installation Note E4440-90613
Installation Procedure
Remove the Top Brace
1. Refer to Figure 2. Use the T-10 driver to remove the top screws (3) (one screw is
under the security label), and the side screws (2) attaching the top brace (1) to the
deck.
2. Remove the top brace from the deck.
Figure 2 Top Brace Removal

Agilent Technologies PSA Series Specifications

General

Brand	Agilent Technologies
Model	PSA Series
Category	Measuring Instruments
Language	English