Agilent Technologies U1241B - Setting Configurations

26 U1241B/U1242B User’s and Service Guide
3 Default Setting Configurations
Setting Configurations
1 Turn off the multimeter.
2 From OFF position, press and hold (Setup) while turning the
rotary switch to any non- OFF position.
To change a menu item setting in Setup mode, perform the following
steps:
1 Press or to scroll through menu items.
2 Press or to scroll through available settings. See Table 3- 9 for
the details of each available option.
3 Press (Save) to save the changes. These parameters remain in
the non- volatile memory.
4 Press and hold (Setup) for more than one second to exit Setup
mode.
NOTE
After you hear a beep, the multimeter is in Setup mode and you can release button.