Doc No. FM5600 issue E Page 26
19. TOUCHSAFE PRO PANEL SETUP
Go to the Touchsafe Pro Master Panel (ID 1), Logon as an Engineer and select the Panel Details option…
Still on Touchsafe Pro Master Panel (ID 1), select the Common Pagers option…
Alternatively, Pagers can be set to operate by Zone - see next page…
S
Pager ID’s (max 6 per site) must be setup in the Paging system – see page 21 for details.
Select which Panel ID the Interface is
being connected to from
the Paging Panel pull-down box.
Note: this only needs to be set on the
Master Panel (ID 1).
Press the Save button then Close to exit.
Enter the 3 digit Pager ID’s
in the boxes
alongside each call type group (Cardiac,
Emergency, etc.) for ones you want to be
notified during the Day, Night 1 and Night 2
modes.
The keypad will be displayed when you click
on a box to enter a pager ID - you may need
to press the 123#? button to select the
numeric keypad.
Press the Save button then Close to exit.
To Next Page
Loading...
