EasyManua.ls Logo

Ailunce HS2 - SSB Communication

Ailunce HS2
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ailunce HS2 HF/VHF/UHF Full Mode SDR Transceiver
Back Homepage
24
SSB communication
2. Long pressPAto quickly select the 5W and 30W sections, and each section can be fine-tuned by the up and down direction keys.
Receive volume, MIC gain
1. Short press theAFbutton to enter the AF interface, use the left and right direction keys to select the setting item, and use the up and down buttons to
set the value.
VOL: volume
MIC: MIC gain
CMP: MIC compression ratio
BAS: Bass
TRB: Treble
Hand microphone selection
1. The HS2 is equipped with a Bluetooth hand microphone. After turning on the Bluetooth hand microphone, the radio will pair itself. After the pairing is
successful, the indicator light of the hand microphone will be green.
2. Wired microphone, plug directly into the MIC port on the front panel.
3. HS2 cannot use any external hand microphone, because the body panel integrates MIC and PTT buttons. After pressing PTT, you can pick up the sound
by talking to the fuselage.
After a simple setup is completed, you can now communicate happily. Usually, LSB mode is used below 7Mh, USB mode is used above 14MHz, and FM
mode is used above 28MHz. Please check your radio license before launching, and abide by local laws and regulations. The HS2 will be locked before
launching (prohibited from launching). Please open it after complying with legal regulations.
1. Press theModekey to select one of the SSB (LSB or USB) modes. If you are operating at 7MHz or below, please select LSB mode.If you are