RF Exposure Information
•DO NOT operate the radio without a proper antenna attached, as this may damage the radio and may also cause you to exceed RF exposure limits. A
proper antenna is an antenna supplied with this radio by the manufacturer or an antenna specifically authorized by the manufacturer for use with this radio,
and the antenna gain shall not exceed the specified gain by the manufacturer declared.
•DO NOT transmit for more than 50% of total radio use time, more than 50% of the time can cause RF exposure compliance requirements to be exceeded.
During transmissions, your radio generates RF energy that can possibly cause interference with other devices or systems. To avoid such interference, turn
off the radio in areas where signs are posted to do so.
•DO NOT operate the transmitter in areas that are sensitive to electromagnetic radiation such as hospitals, aircraft, and blasting sites.
Portable Device, this transmitter may operate with the antenna(s) documented in this filing in Push-to-Talk and body-worn configurations. RF exposure
compliance is limited to the specific belt-clip and accessory configurations as documented in this filing and the separation distance between the user and
the device or its antenna shall be at least 2.5 cm.
Mobile Device, during operation, the separation distance between the user and the antenna subjects to actual regulations, this separation distance will
ensure that there is sufficient distance from a properly installed externally-mounted antenna to satisfy the RF exposure requirements.
Occupational/Controlled Radio, this radio is designed for and classified as”Occupational/Controlled Use Only”, meaning it must be used only during the
course of employment by individuals aware of the hazards, and the ways to minimize such hazards; NOT intended for use in a General
population/uncontrolled environment.
General population/uncontrolled Radio, this radio is designed for and classified as “General population/uncontrolled Radio”.
RF Exposure Compliance and Control Guidelines and Operating Instructions
To control your exposure and ensure compliance with the occupational/controlled environment exposure limits, always adhere to the following procedures.
Guidelines
•User awareness instructions should accompany the device when transferred to other users.
•Do not use this device if the operational requirements described herein are not met.
To Next Page
Loading...