Aim MIL-STD-1553 - Page 475

MIL-STD-1553 Reference Manual
461
Appendix A – Document/Software History
Version
General or S/W Function
Change
Description
ApiCmdBiuIntrCheck
Updated the lla, llb, and llc parameters for
ApiCmdBiuIntrCheck to reflect the ul_Lla, ul_Llb, and
ul_Llc values for the parameters used in the
ApiInstIntHandler function.
ApiReadBSPVersion
Added documentation that this function utilizes Driver Cmd
“0x0034”.
ApiCmdBCAcycPrep
Modified inst parameter to indicate that the BC wait
instruction is not allowed for acyclic minor frames.
Modified xid parameter to indicated that interrupts can be
enabled/disabled for the skip instruction.
ApiCmdBCXferDef
Clarified sxh parameter definition
ApiCmdRTSACon
Corrected names for parameter smod, values 2 and 3.
V16.0
Release for AVI only
V17.0
Release for AVI only
V18.0x
Rev A
General
Corrected global documentation errors
Added detailed return code description for functions
ApiCmdBCAcycPrep
Changed description for parameter ‘instr’
Changed description for parameter ‘xid’
ApiCmdBCAcycSend
Extended send mode capability to send at a pre-defined time
ApiCmdBCAssignFifo
Changed description for parameter ‘xid’
ApiCmdBCBHDef
Corrected type of parameter ‘cnt’, was different
between prototype and parameter description
Corrected description for “buffer header”
ApiCmdBCBHDef
Changed description for parameter ‘hid’
ApiCmdBCDytagDef
Renamed modes Standard Tagging Mode – to Function
mode and EFABus mode to Tagging Mode
ApiCmdBCDytagDef
Changed description for parameter ‘min’
Changed description for parameter ‘bc_hid’
ApiCmdBCFrameDef
Changed description for parameter ‘instr’
ApiCmdBCIni
ApiCmdBCInstrTblGetAddrFrom
Label
ApiCmdBCInstrTblGen
ApiCmdBCInstrTblIni
ApiCmdBCXferDef
Clarified descriptions of function/parameters.
ApiCmdBCInstrTblGen
Added
ApiCmdBCInstrTblGen
Added note to indicate that delay instructions are not allowed
for acyclic instruction table definitions.
ApiCmdBCInstrTblGetAddrFrom
Label
Added
ApiCmdBCInstrTblIni
Added
ApiCmdBCStart
Function changed
added parameter ‘saddr’
extended description for parameter ‘smod’
Clarified which modes were applicable to Standard Framing
Mode and BC Instruction Table Mode.