Aim MIL-STD-1553 - Page 476

MIL-STD-1553 Reference Manual
462
Appendix A – Document/Software History
Version
General or S/W Function
Change
Description
ApiCmdBCXferCtrl
Changed description for parameter ‘xid’
ApiCmdBCXferDef
Corrected documentation error in function
description for ‘brw’ (RBUS) was wrong
Renamed parameter ‘res1’ to ‘rte’
Renamed parameter ‘res2’ to ‘res’
Extended description for parameter ‘rte’
Changed description for parameter ‘xid’
Changed description for parameter ‘hid’
ApiCmdBCXferRead
Changed description for parameter ‘brw’
Changed description for parameter ‘xid’
ApiCmdBite
Extended purpose with a note
ApiCmdBiuIntrCheck
Updated the lla, llb, and llc parameters for
ApiCmdBiuIntrCheck to reflect the ul_Lla, ul_Llb, and
ul_Llc values for the parameters used in the
ApiInstIntHandler function.
ApiCmdBiuIntrCheck
Deleted note in purpose section
Changed description for parameter ‘regs’
ApiCmdBMIniMsgFltRec
Increased the number of maximum message filters from 40
to 255.
ApiCmdBMStackEntryRead
Changes description for parameter ‘offset’
ApiCmdBMStatusRead
Extended description for parameter ‘glb_msg_cnt’
Extended description for parameter ‘glb_err_cnt’
Added parameter ‘glb_word_cnt_pri’
Added parameter ‘glb_word_cnt_sec’
ApiCmdBufDef
Changed description for parameter ‘hid’
ApiCmdBufWrite
Changed description for parameter ‘hid’
ApiCmdDataQueueClose
Added for API only
ApiCmdDataQueueControl
Added for API only
ApiCmdDataQueueOpen
Added for API only
ApiCmdDataQueueRead
Added for API only
ApiCmdExecSys
Added descriptions for Mode 13 (API_OFF, API_ON)
ApiCmdIni
Extended description for parameter ‘prot’ for EFEX support
Changed description for parameter ‘pli_id_biu1’
Changed description for parameter ‘pli_id_biu2’
ApiCmdLoadSRec
Added mode “Api_Start_Rec_Once”
ApiCmdParaRecDef
Added for API only
ApiCmdProgFlash
Changed/extended description for parameter ‘sector’
ApiCmdRTBHDef
Changed description for parameter ‘hid’
ApiCmdRTDytagDef
Changed description for parameter ‘min’
Changed description for parameter ‘rt_hid’
ApiCmdRTEnaDis
Added
ApiCmdRTGlobalCon
Changed description for parameter ‘hid’
ApiCmdRTIni
Added RT Bus Respond Control ‘bus’
ApiCmdRTSACon
Changed description for parameter ‘hid’