- 54 -
6
Setting (GT-2C-L/GT-2C)
How to use the MENU
Security guard station settings
6-1
6-2
1 In the standby mode, press the [ ADJUST] button and [
ZOOM/WIDE] button until the warning screen displays. Press
the [ MENU] button in accordance with the warning screen.
1 After performing steps 1 in section 6-1, select "GUARD SET-
TING" in the "INSTALLATION" screen and press the [
MENU] button.
2 Press the [S], [T], [W], and [X] buttons in the "INSTALLA-
TION" screen to select the item to be set and confirmed, and
press the [
MENU] button.
2 In the "GUARD SETTING" screen, make a selection from
"GUARD1" to "GUARD4" and press the [ MENU] button.
Select from "GUARD/CONCIERGE/RECEPTION/NOT DIS-
PLAYED" for each. Press the [ MENU] button to complete the
settings.
3 To finish changing settings, press the [ OFF] button to return
to the standby mode. In other cases, set by pressing the [
MENU] button. Press the [
REC/PLAY] button to cancel
the settings and return to the previous screen.
INSTALLATION
ALARM INPUT PRESS TO TALK
EXTERNAL INPUT INITIALIZE
GUARD SETTING DOCTOR CALL
GUARD SETTING
GUARD2 [ RECEPTION2 ]
GUARD1 [ GUARD1 ]
GUARD3 [ CONCIERGE3 ]
GUARD4 [ NOT DISPLAYED ]
1. See the operation manual included with the GT-2C-L/GT-2C for the name and operating method for each part.
2. Actual screens may vary depending on the system.
3. When settings are changed, turn the unit power supply off and on again. In some cases, the settings may not be changed.
Change the names of the security guard stations that display with the GT-2C-L/GT-2C.
MOVE ON TO INSTALLATION SETTING?
CHANGING SOME SETTING MAY CAUSE
MALFUNCTION.
CANCEL OK
To Next Page
Loading...
Need help?
General
