40
4.6.3 PPPoE
Set parameters here to enable PPPoE function.
4.6.3.1 For IE, the display will look as below:
Figure 9.2
4.6.3.2 For Safari, Chrome, Firefox, the display will look as below:
Figure 9.3
● Media Port: Default is 38401.
● Web Port: Default is 80.
ONVIF Port: Default is 2012. (Camera supports ONVIF, version 2.0, so you can connect to your additional devices
that support the ONVIF protocol.)
● RTSP Port: Default is 554.
● Enable PPPoE: Choose Open to enable PPPoE function.
● PPPoE User: The account provided by ISP
● PPPoE Password: The password provided by ISP.
● PPPoE IP Addr. If PPPoE dial-up succeed, it will display the IP address distributed by your ISP.
NOTE: Don’t change the Media Port, Web Port, ONVIF Port, RTSP Port if not necessary.
To Next Page
