If the battery is low, the highlight switches on at a minimum level, regardless of the settings.
If you do not touch the buttons for 4 seconds, Keypad will reduce the highlight brightness, and after another 12
seconds, the device will go to the sleep mode.
When switching over to the sleep mode, the keypad will clear the entered commands!
The keypad allows using codes with the length of 4-6 digits. The entered code will be sent to the hub after pressing
the buttons: (activate the guard mode), (deactivate the guard mode) and (с) (Night mode). Erroneously
entered digits can be cleared using the button C (Reset).
If you enter incorrect code three times during 30 minutes, the keypad will be interlocked for the time preset in the
settings. The hub will ignore any entered codes, simultaneously notifying the security system users of the attempt of
guessing the code. The keypad will be unlocked automatically after expiration of the interlock time or manually by the
administrator user.
Keypad also supports setting the system in the armed mode without entering a master code, by pressing the
button (activate the armed mode). These features are disabled by default.
If you press the button * (Function) without entering the password, command * will be sent to the hub and the
function installed in the hub from the application will be executed.
KeyPad can notify a private security company of the system being removed from the guard mode forcibly – using
the Duress code. Unlike the panic button of the fob, if such code is entered, the user will not be compromised by
To Next Page
Loading...
Need help?
General
