The tests do not start immediately but within 36 seconds by default. The starting time depends on the ping interval
(the paragraph on “Jeweller” settings in hub settings).
Jeweller Signal Strength Test
Detection Zone Test
Attenuation Test
Installing the Detector
Selecting the location
Location of DoorProtect is determined by its remoteness from the hub and presence of any obstacles between the
devices hindering the radio signal transmission: walls, inserted floors, large objects located within the room.
Check the signal level at the installation location
If the signal level is low (one bar), we cannot guarantee stable operation of the security system. Take all possible
measures to improve the quality of the signal! As a minimum, move the device — even 20 cm shift can significantly
improve the quality of the reception.
To Next Page
Loading...
Need help?
General
