5. Switch on the power supply. The value of the External Power Supply field in the detector settings will change
to Connected.
Use grounded power supply source only!
6. Fix the rear of the body with screws, install the detector and wait until the end of calibration.
Maintenance
Check the operational capability of the detector regularly. Clean the detector body from dust, spider web, and other
contaminants as they appear. Use soft dry napkin suitable for tech equipment.
Do not use any substances containing alcohol, acetone, gasoline, and other active solvents to clean the detector.
The pre-installed battery ensures up to 5 years of autonomous operation (with the 3 minutes ping interval by the
hub). If the detector battery is low, the system notifies the user, and the LED indicator smoothly lights up and goes
off if a glass break is detected or the tamper is triggered.
Battery replacement
To Next Page
Loading...
Need help?
General
