4. Switch on the device by pressing the on/off button for 3 seconds.
For the detection and interfacing to occur, the detector should be located within the coverage area of the wireless
network of the hub (at a single protected object). Request for connection to the hub is transmitted for a short time at
the time of switching on the device.
MotionProtect Outdoor turns off automatically after 6 seconds, if it failed to connect to the hub. To retry the
connection, you do not need to switch off the device. If the detector has already been assigned to another hub, turn
off MotionProtect Outdoor, and then follow the standard addition procedure.
To Next Page
Loading...
Need help?
General
