During the first hub registration in the app, you will be prompted to add devices to guard the room. However, you can
refuse and return to this step later.
The user can add the device only when the security system is disarmed!
1. Open the room in the app and select the Add Device option.
2. Name the device, scan the QR code (or insert the ID manually), select the room and go to the next step.
3. When the app starts searching and launches countdown, switch on the device: its LED will blink once. For detection
and pairing to occur, the device should be located within the coverage area of the wireless network of the hub (at a
single protected object).
Сonnection request is transmitted for a short time at the moment of switching on the device.
If the connection fails on the first try, switch off the device for 5 seconds and retry.
Up to 10 cameras or DVRs that support RTSP protocol can be connected to Hub.
How to configure and connect an IP camera to the Ajax security system
Settings
To Next Page
Loading...
Need help?
General
