For the detection and interfacing to occur, the siren should be located within the coverage area of the wireless
network of the hub (at a single protected object). If the device was already assigned to another hub, switch off
HomeSiren and then perform the standard adding procedure.
Request for connection to the hub is transmitted for a short time at the time of switching on the device.
If the connection to the Ajax hub failed, the siren will switch off after 6 seconds. You may repeat the connection
attempt then. To retry the connection, you do not need to turn off the device.
The siren connected to the hub will appear in the list of devices of the hub in the application. Update of the siren
statuses in the list depends on the device inquiry time set in the hub settings, with the default value – 36 seconds.
To Next Page
Loading...
Need help?
General
