Temperature of the device. Measured on the processor and
changes gradually
Signal strength between the hub and the siren
Connection status between the hub and the siren
Battery level of the device
The tamper mode of the device, which reacts to the detachment
of or damage to the body
Volume level in case of alarm
Duration of the alarm sound
If active, the siren LED blinks once every 3 seconds when the
security system is armed
Beep when arming/disarming
If active, the siren warns about the activation and deactivation of
the guard mode by the LED and a short sound signal
If activated, siren will beep delays (available in devices
with firmware version 3.50 and later)
Detector firmware version
To Next Page
Loading...
Need help?
General
