1. Fix the SmartBracket panel on the surface using bundled screws. After selecting other attachment hardware, make
sure that they do not damage or deform the panel.
The double-sided adhesive tape may be only used for temporary attachment of the siren. The tape will run dry in course of time, which may result in
the falling and damage of the device.
2. Put the siren on the SmartBracket panel and turn it clockwise. When installing in the attachment panel, the tamper
will switch and the siren will blink with a LED.
If the light indicator of the siren is not actuated after installation in SmartBracket, check the tamper mode in the Ajax
Security System application and then the fixing tightness of the device on the panel.
To Next Page
Loading...
Need help?
General
