For the detection and interfacing to occur, the device should be located within the coverage area of the wireless
network of the hub (at a single protected object).
Request for connection to the hub is transmitted for a short time at the time of switching on the device.
If the connection to the Ajax hub failed, the Transmitter will switch off after 6 seconds. You may repeat the
connection attempt then.
The Transmitter connected to the hub will appear in the list of devices of the hub in the application. Update of device
statuses in the list depends on the device inquiry time set in the hub settings, with the default value – 36 seconds.
States
1. Devices
2. Transmitter
To Next Page
Loading...
Need help?
General
