If before arming the system, the detector has detected motion, it will not arm immediately, but during the next inquiry
by the hub.
Connecting the Detector to the Ajax Security System
Connecting the Detector to the hub
Before starting connection:
1. Following the hub manual recommendations, install the Ajax application. Create an account, add the hub to the
application, and create at least one room.
2. Switch on the hub and check the internet connection (via Ethernet and/or GSM network).
3. Make sure that the hub is disarmed and does not update by checking its status in the app.
Only users with administrator rights can add the device to the hub
To Next Page
Loading...
Need help?
General
