Request for connection to the hub is transmitted for a short time at the moment of switching on the device.
If the detector failed to connect to the hub, switch off the detector for 5 seconds and retry.
The connected detector will appear in the devices list in the application. Update of the detector statuses in the list
depends on the device inquiry time set in the hub settings(default value is 36 seconds).
Connecting the Detector to Third Party security systems
To connect the detector to a third party security central unit with the uartBridge or ocBridge Plus integration module,
follow the recommendations in the manuals of these devices.
States
1. Devices
2. MotionProtect | MotionProtect Plus
To Next Page
Loading...
Need help?
General
