AJAX Hub User Manual

• Low — disregards animals under 50 cm.
Always active
If active, the detector always registers motion
Alert with a siren if motion detected
If active, HomeSiren and StreetSiren are activated when the
motion detected
Jeweller Signal Strength Test
Switches the detector to the signal strength test mode
Detection Zone Test
Switches the detector to the detection area test
Attenuation test
Switches the detector to the signal attenuation test mode
(available in detectors with firmware version 3.50 and later)
User Guide
Opens the User Guide
Unpair device
Disconnects the detector from the hub and deletes its settings
Before using the detector as a part of the security system, set up the suitable sensitivity level.
Switch the Always Active if the detector is located in a room requiring 24-hour control. Regardless of whether the
system is set in the armed mode, you will receive notices of any detected motion.
If any motion is detected, the detector activates the LED for 1 second and transmits an alarm signal to the hub and
then to the user and central monitoring station (if it is connected).
Detector operation indication

AJAX Hub Specifications

General

Brand	AJAX
Model	Hub
Category	Switch
Language	English