AJAX Hub - Page 77

Setting
Value
First field
The detector name, can be edited
Room
Selecting the virtual room to which the device is assigned
Delay When Entering, sec
Setting the delay time when entering
Delay When Leaving, sec
Setting the delay time on exit
Delays in night mode
Delay turned on when using night mode
Arm in Night Mode
If active, the detector will switch to the armed mode when using
the night mode
Primary Detector
If active, DoorProtect primarily reacts to opening/closing
External Сontact Enabled
If active, the detector registers external detector alarms
Always active
If active, the detector always registers opening/closing
Activate the siren if the door or window is open
If active, HomeSiren and StreetSiren are activated when the
opening detected
Activate the siren if an external contact opened
If active, HomeSiren and StreetSiren are activated during an
external detector alarm
Jeweller Signal Strength Test
Switches the detector to the signal strength test mode
Detection Zone Test
Switches the detector to the detection area test
Attenuation Test
Switches the detector to the signal attenuation test mode
(available for detectors with firmware version 3.50 and later)
User Guide
Opens the detector User Guide