Bluetooth Setting
KeyPad TouchScreen supports security modes control by bringing a
smartphone to the sensor. Security management is established through a
Bluetooth communication channel. This method is convenient, secure, and fast,
as there is no need to enter a password, add a phone to the keypad, or use Tag
or Pass that could be lost.
Bluetooth authentication is available only for users.
To enable Bluetooth authentication in the app
To set up Bluetooth authentication
9. Put Pass or Tag with the wide side to the keypad reader for a few seconds. It
is marked with wave icons on the body. Upon successful formatting, you will
receive a notication in the Ajax app and on the keypad display. If the
formatting fails, try again.
10. If you need to reset another Tag or Pass, click Reset another Pass/Tag in
the app. Repeat step 9.
Ajax Security System
1. KeyPad TouchScreen to the hub.Connect
2. Enable the keypad Bluetooth sensor:
Devices → KeyPad Touchscreen → Settings → Enable the Bluetooth toggle.
3. Click Back to save the settings.
1. Open the Ajax Security System app and select the hub to which the KeyPad
TouchScreen with enabled Bluetooth authentication is added. By default,
authentication with Bluetooth is available for all users of such system.
To Next Page
Loading...
Need help?
General
