Page 64 DD8
plus
Version 2.20 - September 1998
NOTE 1: If a wordclock sync source is selected and is being successfully received, the W/C
RCV LED next to the DD8’s barmeter display will illuminate. If this LED flashes, this indicates
that there is some kind of problem with the wordclock (i.e. it is not connected or the cable is
faulty, whatever). Please check your connections.
NOTE 2: Recordings made at a sample rate other than the rate of the external wordclock
source will play back at the wrong speed. For example, if the wordclock being received is
44.1kHz and you try to play back a recording made at 48kHz, the recording will play back
slow. Please make sure that you are receiving the correct wordclock rate.
AUTO DIGITAL INPUT Pressing Auto (F3) moves the cursor to the Auto Digital Input field.
If this field is ON, the Digital Sync automatically switches to the
selected Digital input when tracks are enabled for recording.
EMPHASIS Pressing Emph (F4) moves the cursor to the Emphasis field.
This selects if the emphasis flag will be set on the digital outputs,
and also controls the de-emphasis filter on the DA option board.
SYSTEM - 8
To Next Page
Loading...