Fig. 11
2. OVER HANG ADJUSTMENT
(Refer to Fig. 11)
The distance of the stylus from the turntable shaft
when the tone arm is at the turntable is called "over-
hang". Although the overhang is preset at the factory
for this model, adjustment may be necessary when
the cartridge is replaced. For your convenience, the
rubber turntable mat has indicator groove at the
center for easy overhang adjustment. Bring the tone
arm to the center of the turntable. Adjust the car-
tridge position in the cartridge shall so that the stylus
position is even with the outside groove ring. The
cartridge position is adjustable by resetting the screws
on the cartridge shell.
1,..,' •
15
To Next Page
Loading...
