MICRO SWITCH
(SW901J
PU PLATE (61
Fig. 12
CABINET
3.
SLEEVE POSITION ADJUSTMENT
(Refer to Fig. 13)
The sleeve position adjusts antiskating feature.
1) Put the tone arm in the "stop" state, or on the
arm rest.
2) Set the sleeve, located between the PU Plate and
the chassis, to approximately 45° position as
shown in Fig. 13.
Fig. 13
4. PU PLATE ADJUSTMENT (Refer to Fig. 12)
1) Put the tone arm in the "stop" state.
2) Loosen the screws (b) and (c).
3) Adjust the PU plate (A) so that it may actuate the
micro switch to turn on or off properly.
4) Tighten the screws (b) and (c).
5) Temporarily set the screw (a) in a half screwed
position.
16
To Next Page
Loading...
