A01 Access Control Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
7.LED Setting
7.1. Brightness Setting
If you want to brighten up the brightness in order to see the card reader at
greater ease in an environment with higher light intensity, you need to set up
the related parameters in web Hardware > LED interface.
Parameter Set-up:
Backlight Intensity: adjust the backlight intensity, the bigger value, the
brighter backlight.
Backlight Enabled: tick the check box if want to enable the card reader
LED lighting and vice versa.
Start Time - End Time (H): enter the time span for the LED lighting to be
valid, e.g., if the time span is from 18-22 it means LED light will stay on
during the time span from 6:00 pm to 10:00 pm in one day (24 hours).
Note:
When the check box is unticked, the parameters related to NTP
server will become not editable.
To Next Page
Loading...
Need help?
General
