Akuvox A01 Admin Guide

A01 Access Control Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
11
be delayed for 5 after the door is unlocked.
 Relay Status: relay status is low by default which means normally closed
(NC) If the relay status is high, then it is in Normally Open status (NO).
 Relay Name: name the relay switch according to your need. For example,
you can name the relay switch according to where the relay switch is
located for the convenience.
Note:
 Only the external devices connected to the relay switch needs to be
powered by power adapters as relay switch does not supply power.
10.2.Web Relay Setting
In additional to the relay that is connected to the access control terminal, you
can also control the door access using the network-based web relay on the
device and on the device web interface.
10.2.1.Configure Web Relay on the Web Interface
Web relay needs to set up on the web interface where you are required to fill
in such information as relay IP address, password, web relay action etc.
Before you can achieve the door access via web relay. To configure the
configuration on web Services > Web Relay interface.

Akuvox A01 Specifications

General

Brand	Akuvox
Model	A01
Category	IP Access Controllers
Language	English