A01 Access Control Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
To configure the configuration on web Directory > User > RF Card interface.
You need to click +Add tab to turn to RF Card interface.
Note:
RF card with 13.56 MHz and 125 KHz can be applicable to the
access control terminal for the door access.
12.1.1.1. Configure RF Card Code Format
If you want to integrate with the third-party intercom system in terms of RF
card door access, you can change the RF card code format to be identical
with that applied in the third-party system. To configure the configuration on
web Hardware > Card Reader interface.
Parameter Set-up:
IC/ID Card Display Mode: select the card format for the ID Card for the
door access among five format options: 8H10D; 6H3D5D(W26); 6H8D;
8HN; 8HR. The card code format is 8HN by default in the access control
terminal.
12.1.2. Unlock by NFC
NFC(Near Field Communication) is popular way for door access. It uses radio
waves for data transmission interaction. A01 supports to be unlocked by
NFC. You need to create a card number in user page then add it to your NFC
To Next Page
Loading...
Need help?
General
