A01 Access Control Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
19. Integration with Third Party Device
19.1.Integration via Wiegand
If you want to integrate the A01 access control terminal with the third-party
devices via Wiegand, you can configure the Wiegand on the web Hardware >
Wiegand interface.
Parameter Set-up:
Wiegand Display Mode：select Wigand Card code format among 8H10D;
6H3D5D; 6H8D; 8HN; 8HR; RAW.
Wiegand Card Reader Mode: set the Wiegand data transmission format
among three options: Wiegand 26, Wiegand 34, Wiegand 58. The
transmission format should be identical between the access control
terminal and the device to be integrated.
Wiegand Transfer Mode: set the transfer mode between Input or Output if
the access control terminal is used as a receiver, then set it as “Input” for
the access control terminal and vice versa.
To Next Page
Loading...
Need help?
General
