A03S Access Control Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
9.Network Setting
You can configure the default DHCP mode (Dynamic Host Configuration
Protocol) and static IP connection. Moreover, you can set up IP address,
Subnet Mask, Default Gateway, LAN DNS1 & LAN DNS2. To configure the
configuration on web System > Network > LAN Port interface.
Parameter Set-up:
DHCP: select the DHCP mode by checking off the DHCP box. DHCP mode
is the default network connection. If the DHCP mode is selected, then the
access control terminal will be assigned by the DHCP server with IP
address, subnet mask, default gateway, and DNS server address
automatically.
Static IP: select the static IP mode by checking off the Static IP check
box. When static IP mode is selected, then the IP address, subnet mask,
default gateway, and DNS servers address must be manually configured
according to your actual network environment.
IP Address: set up the IP Address if the static IP mode is selected.
Subnet Mask: set up the subnet mask according to your actual network
environment.
Default Gateway: set up the correct gateway default gateway according
to the IP address of the default gateway.
Preferred/Alternate DNS: set up DNS1/ DNS2 (Domain Name Server)
according to your actual network environment. DNS1 is the primary DNS
server address while the DNS2 is the secondary server address, and the
access control terminal connects to DNS2 server when the primary DNS
server is unavailable.
To Next Page
Loading...
Need help?
General
