A03S Access Control Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
19. Integration with Third Party Device
19.1.Integration via Wiegand
If you want to integrate the access control terminal with the third-party
devices via Wiegand, you can configure the Wiegand on the web Hardware >
Wiegand interface.
Parameter Set-up:
Wiegand Display Mode
：
select Wigand Card code format among 8H10D;
6H3D5D; 6H8D; 8HN; 8HR; RAW.
Wiegand Card Reader Mode: set the Wiegand data transmission format
among three options: Wiegand 26, Wiegand 34, Wiegand 58. The
transmission format should be identical between the access control
terminal and the device to be integrated.
Wiegand Transfer Mode: set the transfer mode between Input or Output if
the access control terminal is used as a receiver, then set it as “Input” for
the access control terminal and vice versa.
Wiegand Input Data Order
：
set the Wiegand input data sequence between
Normal and Reversed if you select Reversed then the input card number
will be reversed an vice versa.
Wiegand Output Data Order: set the Wiegand output data sequence
between Normal and Reversed if you select Reversed then the input card
number will be reversed an vice versa.
Wiegand Output CRC Enable: tick to enable the parity check function to
ensure that signal-based data can be transmitted correctly according to
To Next Page
Loading...
Need help?
General
