A03S Access Control Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
Parameter Set-up:
Power On: select “Power on”, if you want the device to perform Autop
every time it boots up.
Repeatedly: select “Repeatedly”, if you want the device to perform autop
according to the schedule you set up.
Power On + Repeatedly: select “Power On + Repeatedly” if you want to
combine Power On mode and Repeatedly mode that will enable the
device to perform Autop every time it boots up or according to the
schedule you set up.
Hourly Repeat: select “Hourly Repeat” if you want the device to perform
Autop every hour.
18.4.DHCP Provisioning Configuration
Auto-provisioning URL can also be obtained using DHCP option which allows
device to send a request to a DHCP server for a specific DHCP option code. If
you want to use Custom Option as defined by users with option code range
from 128-255), you are required to configure DHCP Custom Option on the
web interface. To set up DHCP AutoP with “Custom Option” and “Power on”
mode. And export Autop Template to edit the configuration. Then set up
DHCP Option on System > Auto Provisioning > DHCP Option interface.
To Next Page
Loading...
Need help?
General
