A03S Access Control Admin Guide
AKUVOX SMART INTERCOM www.akuvox.com
13. Security
13.1.Tamper Alarm Setting
Tamper alarm function serves as a protection against any unauthorized
removal of the devices by triggering off the temper alarm on the device. To
configure the configuration on web System > Security > Tamper Alarm
interface.
Parameter Set-up:
Enable: tick the check box to enable the tamper alarm function. When the
tamper alarm goes off, you can press the Disarm tab beside the check
box to clear the alarm.
Key Status: temper alarm will not be triggered unless the key status is
shifted from “Low” to “High” status.
Note:
Disarm tab will turn gray when the temper alarm is cleared.
The round rubber button at the back of the device must be in
press-down status otherwise the alarm will not be fired.
To Next Page
Loading...
Need help?
General
