Alcatel-Lucent 7330 - Page 235

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-35
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
service_code_ccw A set of one or more service codes,
such as *70, that the user agent
recognizes as the Cancel Call
Waiting service code. This reflects
that fact that in typical dial plans
there are two equivalent ways to
dial a given service code. This is a
string. The value of this property
may include up to two service
codes, each up to 6 characters
long, separated by white space.
The default is “*70 1170.” The
same service code values must be
present in the digit map with an ‘S’
modifier and no ‘R’ modifier.
If a configured value also appears
in the digit map with an S modifier
then they will be processed during
dialing for the associated feature.
If the value is not in the digit map
with an S modifier, then the digits
will be treated as normally dialed
digits and not be specially
processed.
Use the appropriate enable_XXX
parameter to enable the service
code.
For other devices, the value is “*70
1170 and cannot be changed.
NYPackage
A, B, H
only
Yes TL1 using
CANCELWAIT
using
ent-profile-a
cccodes
CLI using
cancel-call-w
ait
using
configure
voice ont
feat-acccode
-prof
service_code_6wc A set of one or more service codes
that the user agent recognizes as a
request to initiate a six-way
conference. This reflects that fact
that in typical dial plans there are
two equivalent ways to dial a given
service code. This is a string. The
value of this property may include
two service codes, each up to 6
characters long, separated by
white space. The default is “*41
1141”.
If a configured value also appears
in the digit map with an S modifier
then they will be processed during
dialing for the associated feature.
If the value is not in the digit map
with an S modifier, then the digits
will be treated as normally dialed
digits and not be specially
processed.
Use the appropriate enable_XXX
parameter to enable the service
code.
NYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(3 of 23)