Alcatel-Lucent 7330 - Page 236

5 — VoIP overview
5-36 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
service_code_rls A set of one or more service codes
that the user agent recognizes as a
request to release a consultation
call that was initiated as part of
six-way conference procedures.
This reflects the fact that in
typical dial plans there are two
equivalent ways to dial a given
service code. This is a string. The
value of this property may include
two service codes, each up to 6
characters long, separated by
white space. The default is “*43
1143”.
If a configured value also appears
in the digit map with an S modifier
then they will be processed during
dialing for the associated feature.
If the value is not in the digit map
with an S modifier, then the digits
will be treated as normally dialed
digits and not be specially
processed.
Use the appropriate enable_XXX
parameter to enable the service
code.
NYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
service_code_hold A set of one or more service codes
that the user agent recognizes as a
request to place the active call on
hold. This reflects that fact that in
typical dial plans there are two
equivalent ways to dial a given
service code. This is a string. The
value of this property may include
up to two service codes, each up to
6 character long, separated by
white space. The default is “*52
1152.”
If a configured value also appears
in the digit map with an S modifier
then they will be processed during
dialing for the associated feature.
If the value is not in the digit map
with an S modifier, then the digits
will be treated as normally dialed
digits and not be specially
processed.
Use the appropriate enable_XXX
parameter to enable the service
code.
For other devices, the value is “*52
1152” and cannot be changed.
NYPackage
A, B, H
only
Yes TL1 using
HOLD using
ent-profile-a
cccodes
CLI using hold
using
configure
voice ont
feat-acccode
-prof
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(4 of 23)