6 — ONT management using an ONT interface
6-14 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
3 Perform one of the following:
a If the ONT is not ranged, start a Telnet session and Telnet to 192.168.4.254.
telnet 192.168.4.254↵
b If the ONT is ranged, start a Telnet session using the IP address of the ONT.
For example:
telnet 192.168.3.10↵
4 Log in to a Telnet session:
login:login
password:password
where
login is the username for the ONT
password is the password for the ONT
The Main menu appears.
5 STOP. This procedure is complete.
Procedure 6-5 To disconnect from the CLI interface
1 Choose option 9, Logout, from the main menu.
2 Perform one of the following:
a If you are connected to the CLI interface through a craft port, disconnect the
serial cable from the RS-232 connector.
b If you are connected to the CLI interface through the first Ethernet port,
disconnect the Ethernet cable from the first Ethernet port.
3 STOP. This procedure is complete.
Note — The 192.168.4.254 IP address remains open until the ONT has
been ranged. After the ONT has been ranged, the ONT no longer
accesses this IP address.
Note — The CLI interface requires a specific username and password.
Contact your Alcatel-Lucent technical support representative for login
and password information.
To Next Page
Loading...
