6 — ONT management using an ONT interface
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 6-15
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Procedure using HTTP interface for Package C ONTs
Package C ONTs support limited configuration using a web-based GUI. The ONT
must support an HTTP server, and the computer must have a supported HTTP client
(Web browser).
The following procedures provide the steps to access the HTTP interface.
Procedure 6-6 Login to web-based GUI
1 Open a web browser and enter the IP address of the ONT in the address bar.
The login window appears.
The default gateway IP address is http://192.168.50.101. You can also obtain the
IP address using DHCP after connecting your PC to the layer 3 UNI.
2 Enter your username and password in the Login window.
The default username is root while the default password is admin.
3 Click OK.
4 STOP. This procedure is complete.
Procedures using CLI interface for Package C ONTs
The CLI interface for Package C ONTs is accessible in two ways:
• craft port—The CLI interface is accessible through a craft port, which is provided
by some ONT models. You connect to the craft port with an RS-232 DB-9
connector, using a VT100 terminal or PC terminal emulation software set at 9600
Baud, 8 bits, no parity.
• Ethernet over LAN—The CLI interface is accessible through an Ethernet port on
an ONT using a computer or laptop with Telnet software.
The following procedures provide the steps to access and to disconnect from the CLI
interface using a craft port, or an Ethernet port.
Note — Contact your Alcatel-Lucent technical support
representative for a list of supported Web browsers.
Note — If you forget the current username and password, press the
reset button for 5 s and the default values for the username and
password will be recovered upon start up.
To Next Page
Loading...
