2 Getting started
In order to have a fully operational 8242 DECT Handset, make sure that you have the following items: the
battery, the AC/DC adapter, the power supply and the USB cable.
2.1 Installing the battery in the telephone
Installing the battery in the telephone
If the belt clip is installed, you must lift it up and maintain it in this position
during the battery installation or replacement. You are advised to proceed
with the belt clip lifted rather than turned.
You can also turn the belt clip counterclockwise.
Position the battery 'connectors ' side as shown in the drawing (A).
Terminate the installation of the battery in its compartment by pressing as
shown in the drawing (B).
Removing the battery from the telephone
If the belt clip is installed, you must lift it up and maintain it in this position
during the battery installation or replacement.
You can also turn the belt clip counterclockwise.
To Next Page
Loading...
