8 Registering the telephone
8.1 Registering the telephone on a system for the first time
For the mobile telephone to function, it must be registered on at least one ALE International PBX. If, when
first switched on, the display indicates: 'Auto install?' your telephone has not been registered on any
system.
Enter the PIN Code (The default is 0000).
Apply.
Select a system (It is recommended that the first empty system is selected).
Enter PARK code (enter nothing if not mandatory).
Press the 'OK' key to confirm.
Enter access code (enter nothing if not mandatory).
Press the 'OK' key to confirm.
Select Power mode (You are advised not to select the 50 mW power mode unless
required. The '50mW power mode' is intended for hazardous sites such as nuclear plants
where it is requested that emissions do not exceed the maximum value.).
Enhanced Security
Yes / No
Call from encrypted system to un-encrypted system is accepted (yes) or rejected (no).
The registration operation can last up to 2 minutes.
If the operation has been done correctly (subscription accepted), the radio reception quality icon is
displayed and the telephone is ready to be used.
If the registration operation has not been successful, the station proposes launching the subscription
again.
Utilization of the telephone in GAP mode can lead to functional limitations for which no claims will be
considered under the terms of the warranty.
To Next Page
Loading...
