Alcatel-Lucent 8242 - Charging the Telephone Battery

8242 DECT Handset
8AL90311USADed01
14 /83
Remove the battery from its compartment as shown in the drawing.
Slide in the memory card from under the two small crescents and press it
as shown in figure.
Position the battery 'connectors ' side as shown in the drawing (A).
Terminate the installation of the battery in its compartment by pressing as
shown in the drawing (B).
Replace the cover.
Switch on the handset.
Dropping the handset may cause the memory card to dislodge inside the handset. When this happens, the
user will be warned via an audible warning signal every 5 seconds, and the message 'Check memory card'
is given. Please insert the memory card correctly in the handset.
2.3 Charging your telephone battery