User Manual
Safety, EMC, EMF, ESD Norms and Equipment Label-
9500 MPR Rel. 3.1
3DB18809AAAA Issue 134/980
1.3 Applicable standards and recommendations
1999/5/CE of 09 March 1999
Safety: EN 60950, EN 60825-1, EN 60825-2, EN 50385
EMC: EN 301 489-1, EN 301 489-4
Spectrum: EN 302 217-2-2
1.4 Safety Rules
Equipment intended for installation in Restricted Access Location
Equipment is only to be accessed by trained service personnel
1.4.1 General Rules
Before carrying out any installation, turn-on, tests or operation and maintenance operations, read carefully
the related sections of this Manual, in particular:
– Hardware Installation
– Commissioning
– Maintenance and Upgrade
Observe safety rules
– When equipment is operating nobody is allowed to have access inside on the equipment parts which
are protected with Cover Plate Shields removable with tools.
– In case of absolute need to have access inside, on the equipment parts when it is operating this is
allowed exclusively to service personnel, where for Service Personnel or Technical assistance is
meant:
• "personnel which has adequate Technical Knowledge and experience necessary to be aware
of the danger that he might find in carrying out an operation and of the necessary measure
-
ments to reduce danger to minimum for him and for others".
• The Service Personnel can only replace the faulty units with spare parts.
• The Service Personnel is not allowed to repair: hence the access to the parts no specified is
not permitted.
• The keys and/or the tools used to open doors, hinged covers to remove parts which give access
to compartments in which are present high dangerous voltages must belong exclusively to the
service personnel.
To Next Page
Loading...
