Alcatel-Lucent 9500 MPR - Page 45

User Manual
Product information and planning
9500 MPR Rel. 3.1
3DB18809AAAA Issue 1 43/980
– Transmitted power control: RTPC function (par. 2.8.12.3 on page 168)
– Power Monitoring (par. 2.8.12.4 on page 168)
– Adaptive Equalization (par. 2.8.12.5 on page 168)
– Link identifier (par. 2.8.12.6 on page 169)
– Loopbacks with MPT-HC/MPT-HC V2/MPT-MC (par. 2.8.12.7 on page 169)
– Loopback activation (par. 2.8.12.8 on page 170)
– Loopback life time (par. 2.8.12.9 on page 170)
• TMN interfaces (par. 2.8.13 on page 171)
• Admission control in Adaptive Modulation (only with ODU300) (par. 2.8.14 on page 171)
– What does “Admission Control” mean? (par. 2.8.14.1 on page 171)
– Radio capacity in case of adaptive modulation (par. 2.8.14.2 on page 171)
– Adaptive modulation and admission control enabled (par. 2.8.14.3 on page 171)
– Adaptive modulation and admission control disabled (par. 2.8.14.4 on page 173)
• Managed Services and profiles (par. 2.8.15 on page 176)
• TDM and Ethernet traffic management (par. 2.8.16 on page 178)
– TDM2TDM (par. 2.8.16.1 on page 180)
– TDM2Eth (par. 2.8.16.2 on page 181)
– SDH2SDH (par. 2.8.16.3 on page 182)
– ETH2ETH (par. 2.8.16.4 on page 182)
• ATM Traffic Management (par. 2.8.17 on page 183)
– ATM Traffic Management on ASAP - PW Label Exp bits and scheduling type (par. 2.8.17.1
on page 187)
– ATM Traffic Management on Modem card - Block biagram for ATM PW Flow policer (par.
2.8.17.2 on page 187)
– Support of ATMoMPLS Protocl Stack (with or without MPLS Tunnel Label (par. 2.8.17.3
on page 187)
• Ethernet Traffic Management (par. 2.8.18 on page 190)
– Bridge type change (par. 2.8.18.1 on page 190)
– Reserved Multicast Addresses (par. 2.8.18.2 on page 190)
• LAG (Link Aggregation Group) (par. 2.8.19 on page 192)
– LAG overview (par. 2.8.19.1 on page 192)
• Quality Of Services (QoS) (par. 2.8.20 on page 194)
– QoS in the Core-E unit (par. 2.8.20.1 on page 194)
– QoS in the Modem unit (par. 2.8.20.2 on page 196)
– QoS in the MPT-HC/MPT-MC (par. 2.8.20.3 on page 198)
• Cross-connections (par. 2.8.21 on page 199)
– E1 Cross-connections (par. 2.8.21.1 on page 199)
– STM-1 Cross-connections (par. 2.8.21.2 on page 199)
– Radio-Radio Cross-connections (par. 2.8.21.3 on page 199)
– Ethernet Cross-connections (par. 2.8.21.4 on page 200)
– ATM PW cross-connections (par. 2.8.21.5 on page 200)
– Port Segregation (par. 2.8.21.6 on page 206)
• Synchronization for PDH/SDH/DATA (par. 2.8.22 on page 211)
– Synchronization overview (par. 2.8.22.1 on page 211)
– Synchronization Sources and protection policy (par. 2.8.22.2 on page 213)
– Synchronization Sources assignment (par. 2.8.22.3 on page 214)
– Synchronization sources assignment rules (par. 2.8.22.4 on page 216)
– Allowed synchronization sources assignment (par. 2.8.22.5 on page 216)
• Synchronization for E1 ports with ASAP unit (par. 2.8.23 on page 218)
• Synchronization distribution from 9500 MPR to 9400 AWY (par. 2.8.24 on page 218)
• Synchronization connection in Stacking configuration with Core protection (par. 2.8.25 on page
219)