H2 DeskPhone
H2P DeskPhone
8AL90394ENAAed01 34 /111
8.7.2 Ringing Mute
⚫ Mute: Press the Mute button when the telephone is in Standby mode:
The top right corner of the telephone screen shows the Bell Mute icon . The red light for the Mute
button is always on. When there is an incoming call, the telephone will display the incoming call
interface but will not ring.
Figure 26 - Ringing mute
⚫ Cancel ring tone mute: On the Standby or Incoming Call screen, press the Mute button again or
volume up to cancel ring tone mute. The Mute icon is no longer shown in the upper right corner
after cancelling . The telephone mute icon is off.
8.8 Hold/resume call
The user can press the [Hold] button to maintain the current call, and this button will become the [Resume]
button. The user can press the "resume" button to restore the call. Sometimes you need to press the [More]
button to find the [Hold] or [Resume] button.
Figure 27 - Call hold interface
8.9 DND
The user may enable the Do-Not-Disturb (DND) feature on the device to reject incoming calls (including call
waiting). The DND can be enabled on a line basis.
To enable/disable all lines DND on the telephone, use one of the following methods:
⚫ Telephone interface: default Standby mode，
1) Press the [DND] button to enter the DND setting interface, select the line or telephone to enable
DND.
2) Press the [DND] button to enter the DND setting interface and disable DND.
Figure 28 - Enable DND
If the user wants to enable/disable uninterrupted function on a specific line, the user can set the
uninterrupted function on the line configuration page.
1) Press the [Setting] >> [Phone] >> [DND] button, Enter [DND] to edit the interface.
To Next Page
Loading...
